Rautenhaus Digital Driver

Rautenhaus digital drivers

The following digital command stations are supported by iTrain:

Driver

Plained above, a loco is halted, if the positive part of the digital power runs from the right rail through the decoder to the left rail but the negative part is blocked by the brake diode. If the posi-tive part of the digital power runs from the left rail, as seen in the direction of travel, via the decoder to the right rail, the loco. Digital Direct for Linux (DDL) via serial line (RS232). With this module the PC is enabled to generate a digital control voltage for Maerklin/Motorola (MM) and/or NMRA/DCC using the serial interface (RS232) hardware. Output lines TxD and GND are used by this feature and must be connected to booster inputs properly.

Rautenhaus Digital Driver
  • Märklin 6021 in combination with 6050/6051
  • Raptor via P50Xr interface
  • TwinCenter
  • Intellibox (P50X)
  • Intellibox II, Basic and COM (LocoNet®*)
  • LocoNet®* (serial, USB and TCP/IP)
  • Lenz XpressNet (serial, USB and LAN/Ethernet)
  • Roco multiMaus only in combination with S88XpressNetLI
  • Rocomotion 10785 (not the 10832)
  • Rautenhaus SLX & RMX
  • Müt MC-2004
  • FCC (Doehler & Haass / MTTT)
  • Zimo MX1 & MX10
  • BiDiB (among others Fichtelbahn)
  • DiCoStation Digital-S-Inside 2 (DSI-Service only on Windows)
  • SPROG only to drive locs and switch accessories (not for programming)
Rautenhaus Digital Driver

Next to the command stations the following devices are supported:

Rautenhaus

Rautenhaus Digital Driver Free

  • GCA-101 (LocoNet®*) via TCP and UDP Multicast
  • HSI-88 (HSI-88 USB only on Windows)
  • Blücher GBMX16XN via USB.
  • OM32 & OC32
  • Games on Track® GT-position (as a feedback interface with loc addresses)

Rautenhaus Digital Drivers

* LocoNet® is property of Digitrax, Inc. and is used under license.